Spares
-
Choke Cable Trunnion Ach9042 Nipple & 53K3503 Screw
- R66.94 excl VAT
- Complete with screw the choke trunnion is used on nearly all SU carb linkages.
-
Float Needle Valve Hs2/4/6 (Viton Tipped)
- R267.80 excl VAT
- This is the original type of needle valve that governs the plastic fuel float in your SU carb. An alternative better upgraded version is available as CA90.
-
Carb Spring (Red 4.5 oz) HS Type Carbs
- R175.08 excl VAT
- Standard spring for all HS2 and HS4 on minis except for the 997/998 Cooper from 1964-9 and H4 special tuning carbs which used AUC4587.
-
Carburettor Lever Pin
- R66.53 excl VAT
- Pin to hold the accelerator cable which locates in the carb bracket lever. Supplied as originally fitted with washers, nut and split pin plus a proper machined hole for the cable unlike many others on the market- which come either bare or with wrong type washers. See AUE34 also for choke cable trunnion
-
Carb Jet Rh Twin HS2/4
- R508.90 excl VAT
- Identified by its pink band this is for the right or rear carb on twin set ups as standard on Cooper and S versions--a longer version of feed pipe for twin HS4 carbs is AUD9102 20 degree float angle.
-
Heater And Choke Cable Clip Hif Carb
- R49.20 excl VAT
- Clip on the heater valve for heater cables on vehicles from 1990 where the in line remote heater valve was used. It has also been used as a clip for HIF carbs to hold the cable but the one from Rover is 13H3472
-
Carb Spacer Hif44 (0.56″Thick) 14.46Mm
- R325.40 excl VAT
- Spacer with gaskets fitted for any 4-bolt fitting carb such as HS6 HIF range about 9/16" (14.5mm). As this is the only thick spacer you need to check stud length.
-
Filter King Fuel Pressure Regulator By Facet 67 mm Glass
- R1,969.40 excl VAT
- The new Filter king has been specially designed to provide a constant and steady flow of fuel under all driving conditions by means of a large and reactive membrane and the following claims are made. 7.9MM (5/16") FEED PIPES ONLY prevents fuel bubbles-reduces the formation of carbon residues-diminishes the danger of fire in the car-improves performance of the engine-enables fuel…
-
Weber Inspection Cover Lid Gasket
- R57.52 excl VAT
- Jet cover gasket for the Weber DCOE range of carburetors
-
Weber DCOE Jet Cover
- R539.20 excl VAT
- Genuine Weber, Imported from the UK Please note that this should not be confused with non-genuine product that is currently available. Insist only on genuine Weber parts for your carburetors Looking for the gasket? Inspection Cover Gasket https://boxergroup.co.za/product/weber-inspection-cover-lid-gasket/
-
Throttle Shaft 40DCOE Early
- R1,518.38 excl VAT
- 40DCOE early throttle shaft Throttle shaft to fit early versions of the Weber 40DCOE Also fits 35 DCNL 38 DCNL 38 DCOE 40 DCNL Please see Related Products tab for Bearings, Lever, Roll pin, Screws and shaft end kit *shaft measures 180mm end to end and is NOT pre drilled for the pump cam.
-
Facet Rubber Mount Kit
- R239.72 excl VAT
- this rubber mounting kit helps to dampen the pump ticking noise as well as acting as an earth
-
Choke Cable Clip For Hs4 Carbs
- R88.41 excl VAT
- Clip for holding the choke cable on the HS carb abutment bracket 12G766.
-
Carb Jet Lh Twin HS2/4
- R524.06 excl VAT
- Jet tube for twin SU carb: If you have a single carb, use AUD9098A although some people interchange with this one. This is for the left hand or front carb and identified by a green band. 20 degree float angle.
-
Carb Spring Yellow 8oz HIF Carbs Only
- R236.03 excl VAT
- Yellow identification spring which is heavier than AUD4355 and is an optional extra. For HIF carbs only.
