Cooling & Heating
-
Silicone Bypass Hose Black
- Long lasting silicon by pass hose between cylinder head and water pump. These are easy to cut and slide on easier than the old conventional rubber type. It has been made this length to fit 1275cc engines which used the longest hose. Cut as required for all other applications, original rubber hoses were GZA2083 and AEG484. Requires GHC608 hose clips…
-
Fan Switch Cooper Mainstream Up to 1992
- FITS INTO SANDWICH PLATE ON CARB COOPER HAS M8 THREAD 8MM WIDE
-
Spring Hose Clip for Fuel/Radiator Hose
- Original 7/16" spring type hose clip as used on later cars (approx 1990 on) for some radiator hoses and fuel lines.
-
Minispares Electric Fan Kit for 1997 On Cars
- Replacement electric fan assembly complete with laser cut metal brackets so that it can be mounted to the original mounting points of the standard fan uses 9" blowing air fan.
-
Radiator Electric Fan Assy Last Carb/SPi Only
- This electic radiator fan was fitted as standard on minis with the large round hole cut out in the inner wing fron 1991. On the 1275 Cooper last carb models there was an earler type fan which is also no longer available. As the original Cooper carb fan is obsolete we have designed a universal fan to fit all cars…
-
Radiator Electric Fan Assy Last Carb/Single Point Inj Only
- This radiator electric fan was fitted as standard on minis with the large round hole cut out in the inner wing fron 1991 on the last carb models through to the SPI but there was an earler type which is no longer available that was on earlier 1275 cooper carb models.
-
Radiator Top Hose Securing Bracket for MPi Stainless Steel
- Spring clip for securing the top hose on MPI front mounted radiator models, now in stainless steel.
-
Radiator Top Hose Securing Bracket for MPi
- Spring clip for securing the top hose on MPI front mounted radiator models.
-
Radiator Bracket Upper L/H Twin Point Front Mounted Rad
- Special bracket for holding the front mounted radiator on twin point injection cars from top of front panel
-
Radiator Bracket PCU10135 In Stainless Steel 1990–96
- Stainless steel version of the upper radiator bracket fitted from 1990 -1996 on cars with one piece rad cowlings when engines were fitted with a sandwich plate under the thermostat housing which made them taller.
-
Radiator Bracket 90–96
- Upper radiator bracket fitted from 1990 -1996 on cars with one piece rad cowlings when engines were fitted with a sandwich plate under the thermostat housing which made them taller.
-
Thermostat to Inlet Plus Heater Hose SPi
- T shape special hose for Single point injection cars only, from thermostat to inlet manifold and heater hose- (221mm)8.75" long on top with the lower bent outlet facing to the left at the bottom, the left top part is (108mm)4 and quarter inches long and top right is (118mm) 4 and five eights--nearly the same,
-
Oil Cooler Temperature Sender Housing
- Oil temperature sender unit housing for checking oil temperature. Fits into the oil cooler hose.(Not compatable with braided hoses) Fitted before the oil cooler will show maximum temperature reached. After the oil cooler it will tell you the all important temperature of the oil going to the engine bearings. In the past, fitting an oil cooler was mandatory once an…
